Project pack · v1.0.0
RP2040 Minimal Board
Bare RP2040 after Raspberry Pi's minimal design: W25Q128 QSPI flash, ABM8-272-T3 12 MHz crystal, internal 1.1 V core regulator, USB-C, BOOTSEL and RESET, 3.3 V LDO, all Pico GPIOs on two 1 × 18 headers.
| Part | Footprint | LCSC |
|---|---|---|
| CC0G 50 V, load for a 10 pF crystal (RP2040 + ABM8-272-T3), basic part | C_0603_1608Metric | C1644 |
| CX5R 16 V, basic part | C_0603_1608Metric | C15849 |
| CX5R 25 V, bulk, basic part | C_0805_2012Metric | C15850 |
| CX7R 50 V, decoupling, basic part | C_0603_1608Metric | C14663 |
| Conn_01x18 | PinHeader_1x18_P2.54mm_Vertical | — |
| USB_C_Receptacle_USB2.0_16PUSB 2.0, 16 pin, SMD + THT legs, extended part | USB_C_Receptacle_HRO_TYPE-C-31-M-12 | C165948 |
| Crystal_GND24the RP2040 design guide's crystal: 10 pF load, 50 Ω ESR, use 15 pF caps + 1 kΩ on XOUT; extended part | Crystal_SMD_3225-4Pin_3.2x2.5mm | C20625731 |
| LED~2 V, 20 mA max, basic part | LED_0603_1608Metric | C2286 |
| W25Q128JVSQSPI, boot flash for RP2040, basic part | SOIC-8_5.3x5.3mm_P1.27mm | C97521 |
| RP2040needs 12 MHz crystal, SPI flash, 1.1 V core decoupling; extended part | QFN-56-1EP_7x7mm_P0.4mm_EP3.2x3.2mm | C2040 |
| AP2112K-3.3500 mA, low dropout, pin-compatible with AP2112K, extended part | SOT-23-5 | C82942 |
| USBLC6-2SC6ST, D+/D− and VBUS clamp, extended part | SOT-23-6 | C7519 |
| PolyfusenSMD050-16V, trips at 1 A; USB VBUS, extended part | Fuse_1206_3216Metric | C70075 |
| R1%, 1/10 W, RP2040 USB D+/D− termination, basic part | R_0603_1608Metric | C25190 |
| R1%, 1/10 W, basic part | R_0603_1608Metric | C21190 |
| R1%, 1/10 W, basic part | R_0603_1608Metric | C23186 |
| SW_Pushreset / boot button, basic part | SW_Push_1P1T_XKB_TS-1187A | C318884 |